C18 ACERT™ OFFSHORE PRODUCTION ENGINE
Cat C18 ACERT™ Fire Pump Engines. Ratings: 447-597 bkW (600-800 bhp)@ 1800-1900 rpm meet U.S. EPA Tier 3 or U.S. EPA Tier 2 emission standards for stationary emergency fire pump engines. Rating: 522 bkW (700 bhp) @ 1500 rpm is Non-certified. FM Approved. UL Listed.
SPECIFICATIONS
Minimum Rating447.0 bkW
Maximum Rating597.0 bkW
EmissionsU.S. EPA Tier, Tier 2 or non-certified
engine specifications
Minimum Rating447.0 bkW
Maximum Rating597.0 bkW
EmissionsU.S. EPA Tier, Tier 2 or non-certified
Rated Speed1750.0 RPM
Bore145.0 mm
Stroke183.0 mm
Displacement18.0 L
AspirationTurbocharged-Aftercooled
Engine Weight, net dry1769.0 kg
Oil Change Interval500.0 hr
Rotation (from flywheel end)Counterclockwise
Flywheel and Flywheel HousingSAE No. 1
Flywheel Teeth113
capacity for liquids
Lube Oil System (refill)37.7 L
Cooling System (engine only)50.0 L
dimensions
Length1889.0 mm
Width1091.0 mm
Height1380.0 mm
C18 ACERT™ STANDARD EQUIPMENT
- air inlet system
Dual turbocharger: front and rear inlet 127.mm (5.0 in)
Separate Circuit Aftercooled (SCAC) - charging system
Charging alternator 24 volt, 50 amp - control system
Dual Electronic Control Units (ECU), primary and secondary
Electronic governing, PTO speed control
Programmable ratings
Cold start capability to -20° C (-4° F)
Automatic altitude compensation
Power compensation for fuel temperature
Programmable low and high idle and total engine limit
Electronic diagnostics and fault logging
Engine monitoring system SAE J1939 broadcast and control - cooling system
Thermostats and housing, vertical outlet
Jacket water pump, centrifugal
Heat exchanger installed
Expansion tank - exhaust system
Exhaust manifold, dry
Dual turbo: exhaust elbow, dry 203 mm (8 in) - flywheels and flywheel housing
SAE No. 1 flywheel
SAE No. 1 flywheel housing
Power take-off (PTO) flywheel stub shaft - fuel system
Electronic unit injector
Fuel filter, secondary (2 micron high performance)
Fuel transfer pump
Fuel priming pump
Fuel sample valve, mounted on fuel filter base
Primary fuel filter
Water separator - instrumentation
Instrument panel, LH
Engine oil pressure gauge
Voltmeter gauge
Water temperature gauge
Tachometer/engine hour meter - lube system
Open crankcase ventilation system
Oil cooler
Lube oil filter
Front sump oil pan
Oil filler
Oil dipstick
Oil pump - mounting system
Front and rear support - protection system
Stop-Start System, automatic (compatible with NFPA 20 requirements, able to be energized from either of two battery sources and capable of manual starter actuation) - starting system
24 volt, LH electric starting motor
Jacket water heater (3 kW, 120-240 volt) - general
Vibration damper
Lifting eyes
Automatic variable timing, electronic
Electronic installation kit, 70 pin connector (connectors, pins, sockets)